Toilet Trouble Rulebook

Table of Contents

Table of Contents

• Before Play
• Assembly
• Setup
• Playing the Game
  • On Your Turn
• WIN!
• Cleaning Up
• To Replace Batteries
• Important: Battery Information
• Caution: To Avoid Injury

Before Play

NOTE: Prior to playing the game, thoroughly clean all surfaces using only tap water.

Assembly

1. Carefully slide the notches of the toilet base through the holes in the game base.
2. Attach the toilet bowl to the toilet base as shown. Gently push down until the parts click together.
3. Attach the toilet tank to the toilet bowl as shown. Firmly push down until the parts click together.

The first time you play, replace the batteries (see "To Replace Batteries" below).

NOTE: Game works best when placed on a flat surface.

Setup

1. Make sure the toilet lid is flipped to the upward position.
2. Fill the toilet bowl to the fill line with clean tap water.
3. Prepare the toilet for gameplay by pressing down on the handle up to 30 times, or until water begins to spray. You may occasionally feel some resistance on the flush, but that's normal. Press down firmly each time until you hear the flushing sound.

Playing the Game

The last person to have used the toilet goes first! Play continues to the left.

On Your Turn

1. Place the toilet in front of you with the toilet bowl facing you.
2. Spin the toilet paper roll spinner.
3. Press down firmly on the handle to flush the toilet the number of times shown on the spinner. You should hear the flushing sound each time.
4. If you only hear a flushing sound but no water is sprayed when you flush, you are safe, and it's the next player's turn. If you get sprayed by the gush of water, you're out!

WIN!

Continue to take turns spinning the toilet paper roll and flushing until only one player is left. The only player not to get sprayed by the toilet wins!

Cleaning Up

1. When you are done playing, pour out all water from the bowl. Then, to ensure that no water remains inside the toilet, flush the handle repeatedly until water stops spraying out. This may take many flushes.
2. Leave the toilet upside down to dry thoroughly. When the toilet is dry, store it in an upright position.

To Replace Batteries

Replace demo batteries with alkaline batteries. Use a Phillips/cross head screwdriver (not included).

Batteries required: 2 x 1.5V AA alkaline. Demo batteries included.

Important: Battery Information

1. To avoid battery leakage: a. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings. b. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. c. Remove exhausted or dead batteries from the product. d. Remove batteries if the product is not to be played with for a long time. e. Do not short-circuit the supply terminals. f. Rechargeable batteries: do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. Do not recharge other types of batteries.
2. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switch off and back on again, or remove and re-insert batteries) if necessary.

Caution: To Avoid Injury

CAUTION: To avoid injury: Use only clean tap water. Dry thoroughly after use. Read instructions thoroughly for use and care instructions.