Ro Sham Bo thumbnail

Ro Sham Bo

Ro Sham Bo Rulebook

Table of Contents

Table of Contents

Components

  • 2 Blue Dice
  • 2 Red Dice
  • Game Board (2 sided)
  • 10 Passive Cards
  • 20 Immediate Cards
  • 4 Immediate Artifacts
  • 2 Passive Artifacts
  • 2 Ruby Rock Units
  • 2 Ruby Paper Units
  • 2 Ruby Scissors Units
  • 2 Teal Rock Units
  • 2 Teal Paper Units
  • 2 Teal Scissors Units
  • Pouch
  • Rule Book

Board Setup

A. Place the board in between the 2 players. Place the units as shown below. Rock, Paper, Scissors, Scissors, Paper, Rock.

B. Arrange 2 decks of the remaining Immediate and Passive cards. Leave room below each deck for a discard pile.

C. Immediate and Passive Artifacts are placed inside the pouch.

D. A set of Red and Blue dice are given to each player.

Who Goes First?

A single game of Rock Paper Scissors is played; the winner is assigned the 1st Player.

Before the game starts, each player has a choice of drawing an Immediate or Passive card. 1st Player draws first and then the 2nd player gets to draw.

During the Artifact Phase the 1st Player is assigned to roll the dice, 2nd player is assigned to pull the Artifact from the pouch and place it on the board.

Objective of the Game

Collect artifacts that will help you with positioning, combat and special abilities. Defeat all of your rivals units to be declared a winner.

Round Order

Artifact Phase: Roll a red and blue die then place a random Artifact.

1st Player Turn

  • If any player is holding a Passive Card, they may equip the card now.
  • Following actions may be taken in any order.
    • You must spend 2 Movement Points.
    • You may collect as many Artifacts on the board.
    • You may initiate an Attack Phase by accouncing it.
      • Attack Phase - Player that initiated the attack rolls first.
      • Counter Phase - Player being attacked gets to roll next.
  • 1st Player must declare their turn is over.

2nd Player Turn

  • Follows the same as the 1st Players turn.
  • 2nd Player must declare their turn is over. A new round begins.

Artifact Phase

In the start of a new round, the 1st player rolls one blue die and one red die. The color and numbers represent coordinates on the board. The 2nd player then randomly chooses an Artifact from the Artifact pouch and places it on the board. Let's go through an example of the Artifact Phase.

A. Blue five and a red three rolled.

B. Pull a random Artifact from the pouch, do not look inside.

C. Place the Artifact here. The dice numbers and colors are coordinates that corresponds to the board.

Artifacts can stack.

Movement Points

During a players turn, they start with 2 Movement Points, they must spend all their Movement Points by the end of their turn. Movement Points can be spent by moving any of their unit 1 space adjacently in any direction that is not occupied by another unit. They can also be spent if a card instructs you to spend points to use it's effect.

Artifact Cards

Move any Unit into the same spot an Artifact occupies to draw Cards. Draw two cards based off the type of Artifact, keep one card and give the rejected card to your opponent or discard both. If you pick up a stack of Artifacts, then draw cards in the order they are placed starting with the top. When an Artifact is picked up, remove it from the board and set aside, when there are no more Artifacts in the pouch, return all the Artifacts that were set aside back into the pouch.

Passive: Players can hold 2 Immediate Cards on their hand. When these cards are played, use its ability then discard it. You can play as many if the card allows it.

Immediate: Players can hold 1 Passive Card on their hand. To equip a card, play it in front face up. A total of two passive cards can be equipped. The cards ability are available to all units until discarded.

Note: the two labels above are transcribed as printed. The printed text under "Passive" describes holding and playing Immediate Cards, and the text under "Immediate" describes equipping Passive Cards, so the labels appear swapped relative to their text. The wording is kept exactly as printed.

Discard any extra cards after a card has been chosen. When there are no more cards, shuffle the discarded pile and place face down.

Attack and Counter Phase

When a player's unit is adjacent to an opponent's unit, they may initiate an Attack Phase. The Player must announce which unit is attacking which unit.

An Attack and Counter Phase are settled by using die/dice. The Player that initiated the Attack Phase rolls first. Then the opponent enters the Counter Phase and then they roll.

The number of dice used depends on the type of units in combat. The number rolled on the die/dice is the damage done to a unit. Whoever inflicts the most damage is the winner. The loser removes their unit from the board and is set aside.

Damage can total over 12 if cards effect adds to the overall amount.

Dice used during combat

The rulebook's "Dice used during combat" diagram shows six unit matchups. Each matchup is a Rock, Paper or Scissors unit of one colour against a unit of the other colour, with the dice drawn beneath each unit:

  • Ruby Rock vs Teal Scissors: two dice (one blue, one red) under the Ruby Rock; one red die under the Teal Scissors.
  • Ruby Paper vs Teal Rock: two dice (one blue, one red) under the Ruby Paper; one red die under the Teal Rock.
  • Ruby Scissors vs Teal Paper: two dice (one blue, one red) under the Ruby Scissors; one red die under the Teal Paper.
  • Teal Rock vs Ruby Rock: one blue die under the Teal Rock; one red die under the Ruby Rock.
  • Teal Paper vs Ruby Paper: one blue die under the Teal Paper; one red die under the Ruby Paper.
  • Teal Scissors vs Ruby Scissors: one blue die under the Teal Scissors; one red die under the Ruby Scissors.

Note: the diagram itself gives no written rule for which unit rolls how many dice; the counts above are read from the illustration as printed.