RulesPal
Chat
Rulebook
Car Wars Supplement, City Blocks 4: 3-D Arena thumbnail

Car Wars Supplement, City Blocks 4: 3-D Arena

Expansion for Car Wars

Car Wars Supplement, City Blocks 4: 3-D Arena Rulebook

Table of Contents

Table of Contents

  • Assembly
  • Flying
  • Falling

Assembly

To assemble the ramps and bunkers, simply cut them out and fold along the dotted lines, then tape or glue them together, following these diagrams:

The assembled pieces can then be placed on any arena map you choose. We recommend using clear, removable tape to keep them on the playing surface.

Flying

With a good takeoff angle (20° to 40°), a vehicle will fly 15 feet for every 10 mph of takeoff speed over 20 (30 mph yields 15 feet of flight, 40 mph results in a 30-foot flight, etc.). A flatter or steeper angle (15° to 19° or 41° to 45°) will cut the distance traveled in half. Inclines flatter than 15°, or steeper than 45°, cannot be used to launch a jump.

Landing is a D1 hazard +D1 for every full 30 feet of flight. Thus, a 15-foot jump is a D1 hazard, a 30- or 45-foot jump is a D2 hazard, a 60- or 75-foot jump is a D3 hazard, and so on. Subtract 1 from the hazard if you land on a downward slope (because all your wheels will hit at about the same time). Add 1 to the hazard if you land on an upward slope. On landing from a jump, roll one die for each tire except solids or off-road solids. On a 1, 2 or 3, that tire takes 1 point of damage.

Falling

Whenever a land vehicle drives off a cliff, curb or crevasse, it will begin to fall. If the vehicle drove off an upward slope, it will jump, rather than fall, as per the flying rules above; if, at the end of the jump, the vehicle has not contacted solid ground, it falls anyway. A falling vehicle collides with the ground after a certain length of time, as per the following table. Obviously, vehicles cannot accelerate, decelerate or jump while in flight.

Height is the height from which the vehicle began the fall. Time is the elapsed time after which the vehicle will land. This time is counted beginning with the phase in which the last portion of the vehicle left the ground; the vehicle takes damage at the beginning of the first movement phase after it lands. For example, a 1" fall takes 1 second. If a vehicle moving 20 mph ends Phase 4 at the edge of a 1" cliff, it will drive completely off the cliff on Phase 7. It will hit the ground below, after 2" of forward movement, at the beginning of its move in Phase 7 of next turn. Finally, Damage is the collision damage assessed to the vehicle.

Dropping one corner over an edge has the same effect as losing all tires on that corner, except that all penalties are removed as soon as the corner is back on the ground.

HeightTimeDamage
¼"5 phases1d-2
½"7 phases1d-1
3/4"9 phases1d-1
1"1 turn1d
1¼"1 turn, 1 phase1d
1½"1 turn, 2 phases1d
1 3/4"1 turn, 3 phases1d
2"1 turn, 4 phases1d
2¼"1 turn, 5 phases

If a vehicle skids, fishtails or drifts so that both corners of one side (not the front or back) are unsupported, it will roll over the edge. It continues at its original speed, rolling one side per movement phase. When it lands, assess the damage to that side (or to each tire if it lands on [word illegible in the printed photograph]). Make a control roll at HC -6 at the vehicle's original speed: if control is regained, the vehicle stops. If the vehicle stays out of control, it continues its roll normally. In addition, on a 4 to 6 on one die, a vehicle that continues its roll will be on fire as well.

If a vehicle drops its two front or back corners off an edge, it continues at its original speed, flipping one facing per turn (it progresses from underbody to front to top to back to underbody). Once it lands, assess damage to the proper side. If the vehicle landed on its front, the very next phase it will fall forward, landing on its top (and taking 1d damage to that location); if on its back, it will fall onto its tires, taking 1d to each. The vehicle then continues on in a straight line, driving normally if on its wheels or decelerating 30 mph per turn if on its roof.

For these rules, a motorcycle has two "corners," one each at the midpoint of the front and back sides. A trike has three, one in the middle of the front (back for a reversed trike) and one at each side on the opposite end.

1d
2½"1 turn, 6 phases1d
2 3/4"1 turn, 7 phases2d
3"1 turn, 7 phases2d
3¼"1 turn, 8 phases2d
3½"1 turn, 9 phases3d
3 3/4"1 turn, 9 phases3d
4"2 turns3d