RulesPal
Chat
Rulebook
Blast Out thumbnail

Blast Out

Blast Out Rulebook

Table of Contents

Table of Contents

  • Object
  • Equipment
  • Assembly
    • 1. Labels
    • 2. Insert Batteries
    • 3. Assemble Support Arms and Clear Funnel
    • 4. Assemble and Attach Shooters and Legs
    • 5. Fences
    • 6. Red Scoring Basket
    • 7. Calibrate the Air Stream
  • Setup
  • Game Play
  • Ending the Round and Scoring
  • Winning
  • Re-Storage

Object

To be the first player to score 10 points by shooting balls into the stream of air, which blasts them up into the scoring basket.

Equipment

  • BLAST OUT machine
  • 12 foam balls
  • Consumer-applied labels
  • 4 "C" size alkaline batteries required (not included)

Note: You must use alkaline batteries in order to provide sufficient air power.

Assembly

Use the drawings on the inside of the rules sheet. Refer to the package photos to see the completed game assembly.

1. Labels

  1. Apply 2 "BLAST OUT" labels to the red blower, one to the front and one to the back, just below the green toggle switch.
  2. Apply the larger circular label in the solid circular area in the center of the blower on the back of the machine (not over the air vents on the front of the machine). Apply the small circular label inside the circle to the right.

2. Insert Batteries

Unsnap and remove the battery compartment door on the base of the machine. Insert 4 "C" size alkaline batteries, aligning the + and - symbols with the + and - printed in the plastic. Replace the door.

3. Assemble Support Arms and Clear Funnel

2 Purple Support Arms:

  1. Snap the curved rectangular hole in an arm over the rectangle on either side of the blower. Then snap the lower end of the arm onto the base.
  2. Repeat with the second support arm on the other side.

Clear Funnel:

  1. Set the clear funnel down onto the top of the blower, as shown. Be sure the holes in the funnel face front and back, as shown, and the tabs on the rim are left and right.
  2. Snap each support arm between the tabs on the rim of the clear funnel.

4. Assemble and Attach Shooters and Legs

4 Gray Shooters and 4 Purple Legs:

  1. Hold a shooter on the diagonal, as shown, and slide it partway into the opening on the shooter leg.
  2. Turn the shooter and leg over. Push the shooter all the way into the leg and press down to lock it in place, as shown.
  3. Compress a spring between your thumb and forefinger. With the shooter and leg still turned over, put the bottom of the spring into the round grey cup on the bottom of the shooter, then release, guiding the top end onto the purple circle.
  4. Assemble the other 3 shooters, arms, and springs.
  5. Snap each leg down over the red "foot" at the base of the blower. (When removing for re-storage, grasp the leg where it connects to the base and twist it left and right, but not down.)
  6. Insert one scoring peg into each leg. Put it in the first hole, closest to the gray shooter.

5. Fences

  1. Locate the two fences with the words "BLAST OUT" cut out. Position these in front of the "BLAST OUT" labels on the blower, front and back. Snap the ends of each section onto the shooter legs.
  2. Repeat with the two plain fences, facing the support arms. Make sure the fences are right side up, the way you installed the two "BLAST OUT" fences; they should not touch the table.

6. Red Scoring Basket

  • Lower the red scoring basket down onto the tops of the support arms, as shown.
  • Double check that the clear funnel, red scoring basket and all 4 legs are aligned securely in place.

7. Calibrate the Air Stream

  • You can adjust the strength of the blast of air with the orange air regulator tab on top of the blower: press down and slide it left and right.
  • The red scoring basket should NOT be on the machine.
  1. Place a single ball into the clear lower funnel.
  2. Turn the machine ON to start the air stream.
  3. Adjust the air regulator tab until the center of the ball lines up with the two markers inside the support arms, as shown. Move the tab left to weaken the air flow, right to strengthen it.
  4. Turn the switch OFF.
  5. If the air stream is too weak to raise the ball to the markers, it's time to change the batteries.

Setup

  • Each player takes 3 balls of the same color and the matching scoring peg.
  • Put your scoring peg in the first hole of your shooter leg, closest to the shooter.
  • Before each game, calibrate the air stream (see the calibration instructions in Assembly, step 7).

Game Play

  • One player turns the machine ON; use the green toggle switch on either side of the blower.
  • All players load one ball into their shooters and launch them simultaneously towards the lower funnel. Do not launch your ball directly into the upper red basket; the balls must use the stream of air to reach the scoring basket!
  • You may load and launch another ball immediately, or wait to see who wins the first battle before you launch again.
  • If your ball is knocked completely out of the air stream, chase it down and re-launch it.

Ending the Round and Scoring

  • The first player who gets his or her three balls into the upper scoring basket shuts the blower OFF and proclaims victory for the round! This player receives 3 points, one for each ball in the basket.
  • All other players receive 1 point for each ball they blasted into the scoring basket.
  • To record points, players move their color scoring pegs up the shooter legs.
  • The player who won the round switches the air back ON and says, "Go!" to start the next round.

Winning

Play as many rounds as necessary until one player reaches 10 points. As soon as a player scores the 10th point, he or she immediately turns the stream of air OFF and is declared the winner! (Any other player's ball that blasts into the scoring basket before the air is shut off counts.)

Note: If during game play the balls aren't blasting out of the tube correctly, check the calibration of the air stream (see the instructions in Assembly, step 7) and adjust it if necessary; be sure to remove the scoring basket before adjusting. Also check that all the parts are aligned and secure.

Re-Storage

Remove the fences, clear funnel, red basket, support arms, and shooter legs from the blower. Leave the gray shooters attached to the purple shooter legs.