RulesPal
Chat
Rulebook
Barikarám thumbnail

Barikarám

Barikarám Rulebook

Table of Contents

Table of Contents

  • Setup
  • Game Flow
    • 1. Selection Phase
    • 2. Herding Phase
  • End of the Game
  • Expansion Modules
    • Expansion Module: The Black Sheep
    • Expansion Module: The Rooster
    • Expansion Module: The Trees
  • Game Components

Setup

  • Each player takes one game board.
  • Put into the bag as many tile sets as there are players, and mix them well together. A set means the 24 tiles with identical backs.
  • Choose a starting player; he takes the 8-sided die.
  • Optionally, prepare the expansion modules as well. These are explained later.

Game Flow

The game is played over several rounds. Each round consists of two parts: 1. the selection phase, 2. the herding phase.

1. Selection Phase

Draw tiles from the bag so that each player gets 4, and then draw four more. So with 2 players draw (3×4=)12 tiles, with 3 players (4×4=)16 tiles, with 4 players (5×4=)20 tiles. Place all of them face up in the middle of the table.

The starting player splits off one set of 4 tiles from the large pile. He may use any 4 tiles he likes for it.

The next player, and generally every player after him, has two options: either he takes the already split-off 4-tile set and places it in front of him, or he also splits off 4 tiles from the large pile. If he chooses to split off, the next player may then choose from two 4-tile sets.

If there is no split-off 4-tile set at the moment, or there is no large pile left from which 4 tiles could be chosen, then only one option is available.

Once every player has chosen 4 tiles for himself by the method above, one 4-tile set remains in the middle of the table for the next round.

The herding phase may begin, which is also started by the starting player.

2. Herding Phase

In the herding phase you must do the following:

  1. The starting player rolls the die once. The result applies to everyone.
  2. Each player places one of his tiles on his game board, on the corresponding place.
  3. One of your tiles must be pushed one step onto an adjacent square.

Tile placement rules:

  • Each number rolled on the die corresponds to 2 fields on the board. The player decides which of the 2 possible options to choose.
  • If the outer field marked with the matching number is empty, simply place the tile on it! If you would place a fox or wolf there, you must immediately slide it one step further in. Thus they (except on fields 1 and 5) end up in the pen.
  • If your chosen set contains a fox or wolf, you must place these tiles on the board first.
  • If the chosen field is not empty, the placed tile pushes the tile(s) in front of it in the direction of arrival (at the corners, either horizontally or vertically). As a result, it may push tiles out of the pen, and even push them off the board. (Tiles pushed off the board never return to the game.) Since foxes and wolves are immediately slid one step further in, they may push tiles on the board by up to 2 fields.

Tile movement rules:

  • After placing a tile on the board, you must move one tile. This may even be the one you have just placed.
  • A tile can always be pushed onto an adjacent empty field; it may not push other tiles in front of it, and it must not leave the pen.
  • The exception to the general rules is the farmer: during movement he may also push other tile(s), and he may leave the pen, but he may not step off the board.

These three steps must be repeated four times, until your chosen tiles run out. When this is done, the round ends and the selection phase follows again.

End of the Game

The game ends when:

  1. one of the players has filled his pen (all 9 squares), or
  2. the players no longer have enough tiles to draw for the selection phase.

Then each player adds up the points of his pen, i.e., counts his sheep inside the pen, and subtracts any negative points. The player with the highest score wins. In case of a tie, the one who managed to herd more sheep wins.

In scoring, each sheep tile is worth as many points as there are sheep on it. The hen and the farmer are worth 0 points, while the fox is worth −1 point and the wolf −2 points, if they are inside the pen at the end of the game.

The rulebook shows a worked scoring example on a board diagram (values shown on the pen fields: +1, +3, −1, −2, 0, +5, 0, 0, +2, 0). The diagram is not reproduced as text.

Expansion Modules

You may have found further tiles in the box, with which you can try other game variants. Any expansion module can be used on its own, or all of them together with the base game components.

Expansion Module: The Black Sheep

Each player places one black sheep tile of value 1 and one of value 2, each on any 1 field inside his own pen. During the game, you must try to push the black sheep out of the pen. If this does not succeed, the player gets no points for a black sheep that remains inside his pen, but every opponent receives the points shown on that tile.

Expansion Module: The Rooster

In this variant, each player replaces one hen tile with a rooster. These go into the bag together with the other tiles, as described above.

If you place a rooster on the board and it lands directly next to one or more hens, then both the rooster and the affected hens leave the board. You may also activate this function of the rooster if it comes next to hens during movement. Each rooster can be used only once, but before using it you may calmly wait until more hens drift next to the rooster.

Expansion Module: The Trees

Each player takes 2 trees and places them on any 2 fields outside his pen. During the game these fields are occupied and block certain possibilities:

  • A field occupied by a tree cannot be entered by a tile, except from the opposite side.
  • If a row is pushed in the direction of a tree, the row ends before the tree: the last tile in that row falls off the board already at the edge of the pen.

The tree does not only hinder play; the shortened rows also give new and interesting tactical possibilities.

Game Components

  • 4 identical tile sets (4×24 tiles)
  • 1 expansion tile set (4×5 tiles)
  • 4 game boards, with the pen in the middle
  • 1 eight-sided die
  • 1 drawing bag

In each base tile set: 2×5 sheep, 3×4 sheep, 3×3 sheep, 4×2 sheep, 4×1 sheep, 1 farmer, 1 wolf, 2 foxes, 4 hens.

In the expansion tile set: 4 roosters, 4×2 black sheep, 4×1 black sheep, 8 trees.